Vip1200 Manual

After plugging in your set-top box, wait until on-screen instructions appear on your TV. They should appear after about a minute. These instructions will walk you through pairing the Set-Top Box to the Wireless Access Point.

• Motorola Vip1200 Manual

Motorola Vip1200 Manual

Pairing creates a secure wireless bond between the Set-Top box and the Wireless Access Point. To start the pairing, press the OK button on the front of the Wireless Set-Top Box. On your TV screen, you will see a gray and white antenna as it searches for the wireless access point. Now, go to the Wireless Access Point. And press the Wi-Fi Protected Setup (or WPS) button on the WAP. You'll see a fast-blinking green LED bar under the button.

Onan p2200g service manual. Check your TV screen to make sure the pairing is successful. The Link light on the front of the Set-top box will be solid green when the pairing is successful.

Either indicates a successful pairing. Three green LED bars on the front of the Set-Top Box indicate that you are getting adequate signal strength from the Wireless Access Point. If you don't see three bars, you may need to move the Wireless Set-Top box closer to the Wireless Access Point. Your wireless Set-Top box will continue to boot up and receive software updates for up to ten minutes.

Do not turn off your Set-Top Box while it boots. When the box has completely booted up and the pairing is successful, you will see Prism programming.

If the pairing fails, you will need to restart the Wireless Set-Top Box and begin the pairing process again. If you still see a red antenna, you may need to move your Set-Top Box closer to your Wireless Access Point and repeat the pairing process.