2015 Can Am Outlander 400 Owners Manual
GENERAL Maintenance is very important for keeping the vehicle in a safe operating condition. Proper maintenance is the OWNER’S responsibility. Your vehicle should be serviced as per the maintenance schedule. Failure to properly maintain the vehicle according to the maintenance schedule and procedures can make it unsafe to operate.
MAINTENANCE SOON MESSAGE The following message will appear in the cluster after the first 10 hours of operation and then at every 50 hours that follow as a reminder of when an inspection is due: MAINTENANCE SOON. The message can be cancelled by alternatively pressing the override button and the brake pedal 3 times or by using B.U.D.S. Software SEVERE DUSTY CONDITIONS ENGINE AIR FILTER MAINTENANCE GUIDELINE Air filter maintenance should be adjusted according to riding conditions. Air filter maintenance must be increased in frequency in the following dusty conditions. Riding on dry sand. Riding on dry dirt covered surfaces. Riding on dry gravel roads or similar conditions.
Can-am Outlander 400 Xt
NOTE: Riding in a group in these conditions would increase even more the air filter maintenance, MAINTENANCE SCHEDULE Follow the appropriate intervals according to the environment where te vehicle is used: normal environment (mud, water, dust). EVERY 750 KM (500 MI) or 25 HOURS OF OPERATION IN A NORMAL ENVIRONMENT (whichever comes first) EVERY 375 KM (250 MI) OR 12.5 HOURS OF OPERATION IN AN EXTREME ENVIRONMENT (whichever comes first).
Inspect and clean (or replace if necessary) engine air filter and foam filter.
Product Description. A special blend of fibers and resin creates a proprietary filter media that captures 95% 1 of the dirt particles that can cause harmful engine wear.
Start-up engine protection is delivered through a precision molded silicone anti drain back valve. The perfect balance of dirt-trapping efficiency and dirt-holding capacity. Sure Grip® coating provides a non-slip finish for easier installation and removal.
Engineered for conventional and synthetic oil types. Internally lubricated sealing gasket for easier filter removal. Use proper protective gear.
Used motor oil should not come in contact with bare skin. Engine oil may be hot. Place a drain pan under the oil filter and unscrew oil filter. Clean mounting base, making sure the O-ring from the old filter is not stuck to the filter mount.
Apply film of clean oil to filter gasket. Do not use grease. Screw new filter on until gasket reaches base contact.
Then tighten according to instructions on filter using tightening guide markers. Check owner’s manual for correct oil specification, viscosity and amount. Add oil to “full” on dipstick. Idle engine for 5 minutes and check for leaks. Shut off engine and recheck oil level after 5 minutes and top off as necessary.